Husqvarna FS5000 D Operator's Manual page 25

15. If the product has a blade clutch, push the button
adjacent to the blade clutch symbol on the display.
The symbol on the display changes color to show
that the drive on the cutting blade is disengaged.
3
4
< 1200 RPM
180
150 210
110 250
˚F
STOP:
50 cm
Straight operation of the product on page
Note: Refer to
25 for information about how to adjust the rear axle if
the product does not cut straight.
To use the correct working technique
• Stay away from the blade path while the engine is
on. The correct operator position is between the
handles.
• Examine the cutting blade frequently for cracks and
broken parts during the work day. Do not use a
damaged cutting blade.
WARNING: Stop the engine before you
examine the cutting blade.
• Do not grind with the side of the cutting blade. The
cutting blade can break and cause injury to the
operator or bystanders. Only use the cutting edge.
• Do not bend or twist the cutting blade in the cut.
• Make sure that the cutting blade moves freely and
does not catch in the cut.
Straight operation of the product
During operation, the cutting blade causes resistance to
the forward movement from the rear wheels. This
causes the product to steer in the same direction as the
cutting blade is installed. To prevent a bent cut, the
angle of the rear axle can be adjusted. There are 2
procedures to adjust the rear axle, with the E-track
function or with a manual axle adjustment.
1143 - 002 - 08.07.2019
To adjust the rear axle with the E-track
function
You can do the rear axle adjustment with the E-track
function during operation or when the product is
stationary.
• Push the left and right E-track adjustment buttons
(A) to adjust the rear axle. Push again and again for
small adjustments.
A B
12
10 14
8 18
V
Note: The E-track gauge (C) on the display shows
the current angle of the rear axle. The adjustment is
saved when the ignition is off or if the product
becomes without power.
• Look at the movement and the direction of the
product to make sure that the adjustment is correct.
• To reset the rear axle to the center angle that is set
in the system, push the E-track reset button (B).
• To go back to the adjusted angle, push the E-track
reset button again.
• To adjust the center angle that is set in the system,
refer to the operator's manual for the control panel.
To adjust the rear axle manually
• Turn the adjustment bolt at the lower left at the rear
of the product. Use an 18 mm wrench.
a) If the product steers to the right during operation,
turn the adjustment bolt counterclockwise.
b) If the product steers to the left during operation,
turn the adjustment bolt clockwise.
C
0
2
1 3
0 4
< 1200 RPM
180
150 210
5.0
WORKING HOURS 110 250
˚F
CURRENT: STOP:
A
25