Maintenance - Husqvarna FS5000 D Operator's Manual

To stop the product
1. Turn the knob for the throttle control to the low idle
position.
2. Close the water valve.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
For all servicing and repair work on the product, special
training is necessary. We guarantee that professional
repairs and servicing is available. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For spare parts, speak to your Husqvarna dealer or
service agent.
To do before the maintenance
• Park the product on a level surface and stop the
engine. Push the machine stop button on the control
panel to prevent accidental start during

maintenance.

Maintenance
Clean the product.
Do a check of the radiator coolant level.
Do a check of the engine oil level.
26
3. Let the engine operate at idle speed for 2-3 minutes.
4. Turn the engine start switch to the stop position (A).
Maintenance
• Clean the area around the product from oil and dirt.
Remove unwanted objects.
• Put clear signs around the maintenance area to give
a warning to bystanders that maintenance work is in
progress.
• Keep fire extinguishers, medical supplies and an
emergency phone near.
Maintenance schedule
Note: If more than 1 time interval is identified in a table
row, the shortest time interval is for the first maintenance
only.
Safety devices on the product on page 11 for
* Refer to
instructions.
Daily and
after
transpor-
tation
X
X
X
WARNING: The cutting blade continues to
rotate for a while after the engine stops. Do
not stop the cutting blade with your hands.
Serious injuries can occur.
50 h 100 h 250 h
1143 - 002 - 08.07.2019
A
500 h Yearly