Time Slot Assignment - Paradyne FrameSaver SLV 9126 Installation Instructions Manual

Setting Up Physical Interfaces
1. Select each interface's physical configuration options.
Configuration
Configuration
Configuration
If installing a FrameSaver SLV NAM with an ISDN DBM, postpone configuring the
DBM interface until later.
2. Configure the Network and DSX-1 interfaces to match the network provider's
settings. Be sure to enable the Interface Status option for these interfaces.
(The network interface is already enabled on a FrameSaver SLV NAM.)
Configure Data Ports to match the DTE's settings. If Port-2 will be used, enable the
Port Status option for the port.
3. Save the configurations.
Setting Frame Relay Characteristics
When installing a FrameSaver SLV NAM, frame relay characteristics must be
configured for the network and data ports.
1. Select the interface's frame relay configuration options.
Configuration
Configuration
2. Configure each interface according to the local management interface (LMI ) and
assigned line conditions supplied by the service provider.
3. Save the configurations.

Time Slot Assignment

FrameSaver SLV NAM frame relay (network) time slots are discovered automatically
when Time Slot Discovery is enabled (the default setting) on the Frame Relay
Network 1 Assignments screen. This feature can be disabled if you want to manually
configure time slots.
See Assigning Time Slots/Cross Connections in Configuration of the User's Guide for
additional information about this feature.
Network Physical
Data Ports Physical
DSX-1 (if the DSX-1 interface will be used)
Network Frame Relay
Data Ports Frame Relay
7