Verifying That Self-Test Passed; Setting The System Clock - Paradyne FrameSaver SLV 9126 Installation Instructions Manual

The FrameSaver unit is set to automatically configure the following:
Time Slot Assignment
Auto-Configuration
It is assumed that the unit is configured for factory default settings at the start of the
installation, and that the automatic configuration features will be used. See Time Slot
Assignment on page 7 and Automatic Configuration on page 9 for information about
these features.

Verifying that Self-Test Passed

To verify that the unit passed its self-test, go to the System and Test Status screen.
Main Menu
The results of the self-test appears directly under the screen title.
If any failure messages appear, reset the unit by disconnecting, then reconnecting the
power cord. The unit will perform the self-test again. If the failure reappears, call your
service representative for assistance.

Setting the System Clock

1. Select System Information.
Main Menu
2. Move the cursor to the Date, then the Time field to enter:
– Date in the mm/dd/yyyy format (month/day/year)
– Time in the hh:mm format (hours:minutes)
3. Save the settings.
Assigning the Node IP Address
1. Set up the node.
Main Menu
2. Minimally, enter the following options:
– Node IP Address
– Node Subnet Mask
3. Save the configuration.
Status System and Test Status
Control System Information
Configuration Management and Communication
6
Node IP