Government Requirements - Paradyne FrameSaver SLV 9126 Installation Instructions Manual

Government Requirements

Certain governments require that instructions pertaining to connection to the telephone
network be included in the user documentation. Specific instructions are listed in the
following sections.
United States
Notice to Users of the Telephone Network
This equipment complies with Part 68 of the FCC rules. On the bottom of the housing is
a label that contains, among other information, the FCC registration number for this
equipment. If the unit comes with an integral modem, the ringer equivalence number
(REN) will also be labeled. If requested, please provide this information to your
telephone company.
The REN is used to determine the number of devices that may be connected to the
telephone line. Excessive RENs on the line may result in the devices not ringing in
response to an incoming call. In most, but not all areas, the sum of RENs should not
exceed five (5.0). To be certain of the number of devices that can be connected to the
line, as determined by the total RENs, contact the local telephone company.
If your unit causes harm to the telephone network, the telephone company may
discontinue your service temporarily. If possible, they will notify you in advance. But if
advance notice is not practical, you will be notified as soon as possible. You will be
advised of your right to file a complaint with the FCC.
Your telephone company may make changes in facilities, equipment, operations, or
procedures that could affect the proper operation of your equipment. If so, you will be
given advance notice so as to give you an opportunity to maintain uninterrupted
service.
No repairs may be performed by the user. Should you experience difficulty with this
equipment, refer to the Warranty, Sales, Service, and Training Information on page 24.
Make the T1 network connection using a Universal Service Order Code (USOC) type
RJ48C jack for single-line installations and type RJ48H jack for multiline installations.
Specify both the Service Order Code 6.0F, as well as the proper Facility Interface
Code, to the telephone company when ordering the T1 line. The T1 equipment can be
configured to support any of the framing format and line signaling techniques shown in
the table below. The T1 equipment's configuration must correspond to the T1 line's
parameters.
T1 Facility Interface Codes
Interface Code
04DU9-BN
04DU9-DN
04DU9-1KN
04DU-1SN
Description
1.544 Mbps superframe format (SF) without line power
1.544 Mbps SF and B8ZS without line power
1.544 Mbps ANSI ESF without line power
1.544 Mbps ANSI ESF and B8ZS without line power
21