System Level Configuration; Configure Network Settings; Configure Sip Interface Settings - Avaya J100 Series Configuration Manual

System Level Configuration

This section describes system-wide configuration items in the
generally required for each Avaya J129 IP Phone to work with. Subscriber-specific settings are described
in the next section. For parameter description, see the Installing and Administering Avaya J129 IP Phone
in third-party call control setup for J129.

1.1.1 Configure Network Settings

Step
Step 1
Step 2
Step 3
Step 4
Step 5

1.1.2 Configure SIP Interface Settings

Step
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Step 12
Step 13
Step 14
Step 15
Step 16
Step 17
Step 18
Step 19
Step 20
Step 21
Command
SET ENABLE_UDP_TRANSPORT 1
SET DNSSRVR "8.8.8.8"
SET DOMAIN ""
SET SNTPSRVR pool.ntp.org
SET SNTP_SYNC_INTERVAL 144000
Command
"opensip.com"
SET SIPDOMAIN
SET SIP_CONTROLLER_LIST 10.133.131.189:5061:transport=tls (udp or
tcp using port 5060)
SET ENABLE_G711A 1
SET ENABLE_G711U 1
SET ENABLE_G722 1
SET ENABLE_G726 0
SET G726_PAYLOAD_TYPE 110
SET ENABLE_G729 1
SET ENABLE_OPUS 0
SET SEND_DTMF_TYPE 2
SET DTMF_PAYLOAD_TYPE 120
SET 100REL_SUPPORT 1
SET PLAY_TONE_UNTIL_RTP 1
SET SYMMETRIC_RTP 1
SET REGISTERWAIT 1200
SET WAIT_FOR_UNREGISTRATION_TIMER 32
SET WAIT_FOR_INVITE_RESPONSE_TIMEOUT 60
SET FAILED_SESSION_REMOVAL_TIMER 30
SET TCP_KEEP_ALIVE_STATUS 1
SET TCP_KEEP_ALIVE_TIME 60
SET TCP_KEEP_ALIVE_INTERVAL 10
file that are
6