ABC Design Primo Instructions For Use Manual page 8

1. Opening the pushchair
a. Pull the catch up to release the transportation lock.
Unfold the pushchair.
b. Press the rear strut down to lock the pushchair into its open position.
CAUTION: Ensure that all the catches are engaged before use.
2. Mounting the front wheels
a. Push the front wheels into the fittings until they click into place.
b. To remove the front wheels again, press the catches on the wheel fittings.
c. Push the rear wheel blocks into the fittings until they click into place.
d. Hook the cross bracing into place.
3. Using the brakes
Press the lever down to apply the brakes.
Press the lever up to release the brakes.
4. Adjusting the handles
To adjust the handle, press the catch under the handle down.
Turn the handle to the required position and let go of the catch again so that the handle clicks into the new
position.
5. Fastening the harness
To fasten the harness push the two plastic catches (1) together until they engage.
Adjust the strap to a setting where the baby is held in the correct position.
6. Unfastening the harness
To unfasten the harness, press the button (1) slightly offset to the left and right.
Caution: Always use the shoulder harness and lap belt together.
7. Positioning the sun canopy
a. First release the catch on the rear of the hood.
b. Open the hood out over the pushchair.
8. Adjusting the backrest
Pull up the plastic catch located on the rear of the backrest and move the backrest to the required position.
Let the catch go again to allow the backrest to click into the selected position.
EN - 05