Smoke Detector - Eaton Powerware User Manual

Smoke Detector

IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important instructions that you should follow during installation and
maintenance of the smoke detector. Please read all instructions before operating the equipment
and save this manual for future reference.
S
This smoke detector uses a high technology electronic chamber. All repairs and service
should be performed by AUTHORIZED SERVICE PERSONNEL ONLY.
S
The smoke detector is not warranted to protect lives or property from fire. In addition, it is
possible for the smoke detector to fail at any time.
Avoid placing the smoke detector in the following locations:
S
In front of forced air ducts used for heating and air conditioning and other high air flow
areas.
S
In the peak of an "A" frame type of ceiling.
S
In areas where temperatures may fall below 4°C (40°F) or rise above 38°C (100°F).
S
In dusty areas (dust particles may cause the smoke detector to set off a false alarm or the
smoke detector may fail to alarm).
S
In very humid areas (moisture can cause the smoke detector to set off a false alarm).
S
Near electrical lights (electrical "noise" from the lights may cause a nuisance alarm). Place
the smoke detector at least 1.5m (5 ft) from such lights.
The smoke detector is a device that works with the Eaton Powerware
Environmental Rack Monitor (ERM) and connects to the TH-Module.
Through the ERM, the user can monitor if there is smoke. The smoke
detector is powered by 110 Vac/220 Vac and uses a 9-volt battery as a
back-up power supply. AC/DC smoke detectors offer added protection in
the event of a power failure or a drained battery.
There are two types of smoke detectors:
S
- AC110V, DC9V Battery with a NEMA Plug
Type A
S
- AC220V, DC9V Battery with an IEC Plug
Type B
EATON Powerware
W A R N I N G
C A U T I O N
® Smoke Detector User's Guide S 164201680 Rev 1 3