Safety Messages Contained In This Manual - GTT Opticom GPS System Installation Manual

4
2.4 Safety Messages Contained in this
Manual
The following safety messages appear in this
manual:
WARNING
This equipment has been approved for mobile
applications where the equipment should be
used at distances greater than 20 cm from the
human body (with the exception of hands,
wrists, feet and ankles). Operation at distances
less than 20 cm is strictly prohibited.
NOTE: This equipment has been tested and
found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated in
a commercial environment. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be
required to correct the interference at his own
expense.
NOTICE
This Class A digital apparatus complies
with Canadian ICES-003.
Cet appareil numérique de la classe A
conforme à la norme NMB-003 du
Canada.
IMPORTANT NOTE
Modifying the radio/GPS unit may seriously
damage the equipment and void the warranty.
Do not attempt to modify the radio/GPS
circuitry in any way. Modifying the radio and/or
antenna in any way may cause the radio to
violate FCC/IC requirements.
Intersection Equipment Installation Instructions
REMARQUE IMPORTANTE
La modification du système radio/GPS risque
d'endommager sérieusement le matériel et d'annuler
la garantie. Ne pas tenter de modifier les circuits du
système radio/GPS de quelque façon que ce soit. En
modifiant le système radio et/ou l'antenne de quelque
façon que ce soit, la radio risque de ne plus répondre
aux exigences de la FCC/IC.
Improper or incomplete programming of the
traffic controller may cause improper operation
of the traffic signals, which may result in
accidents and/or injuries. To avoid this
problem, verify that the operation of the traffic
controller is appropriate for your needs before,
during, and after actuation of the priority
control inputs. Improper operation of the
traffic signals may result in unsafe driver action.
This procedure may expose you to AC voltage
and the risk of electric shock or electrocution.
Turn off the AC mains and use accepted and
recognized safety precautions to avoid
exposure to the risk of electric shock or
electrocution. Electric shock may cause severe
injury or death.
WARNING
WARNING