Additional Output Connections - GTT Opticom GPS System Installation Manual

30

5.5.4.1 Additional Output Connections

If a Opticom™ GPS System Phase Selector will be
requires more than 4 outputs, it is necessary to
make additional connections between the
auxiliary interface panel and the traffic control
cabinet wiring. Outputs for the Time Sync output
function are also available on the AIP. See the ITS
Explorer help file for details.
Table 5-3 shows the function of the auxiliary
interface panel outputs for the various modes of
operation.
1. Determine the appropriate length of the wires
required to connect the auxiliary interface
panel to the wiring points in the traffic control
cabinet.
Output Terminal Block & Signal
TB1 PHASE OMIT 1
1
2 TB1 PHASE OMIT 2
3 TB1 PHASE OMIT 3
4 TB1 PHASE OMIT 4
5 TB1 PHASE OMIT 5
6 TB1 PHASE OMIT 6
7 TB1 PHASE OMIT 7
8 TB1 PHASE OMIT 8
9 TB1 MANUAL CTRL EN
10 TB1 FREE OUTPUT
11 TB1 COORD ISOL
12 TB1 INT ADV
13 TB2 CONFIRM 1
14 TB2 CONFIRM 2
15 TB2 CONFIRM 3
16 TB2 CONFIRM 4
TB1 or TB2
OPTO
OPTO COMMON
COMMON
Intersection Equipment Installation Instructions
2. Strip 1/4 inch of insulation from both ends of
3. Insert one end of each wire into the desired
4. Repeat step 3 for all desired connections.
5. Route the wires through the traffic control
6. Insert one wire at a time into the correct
7. Verify that your wiring is correct, and the
8. Use the configuration software to make the
Table 5-3. Function of AIP outputs
Availability
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Preempt or TSP
Assignable via software for Time Sync
Assignable via software for Time Sync
Assignable via software for Time Sync
Assignable via software for Time Sync
Future
Future
Future
Future
Logic Common
the wires being used.
terminal of the auxiliary interface panel and
tighten the screw.
cabinet. Install spade lugs on the wires.
terminal and tighten the screw.
connections are tight.
appropriate assignments for the outputs.