Advertisement
Quick Links
Download this manual
See also:
Instruction Booklet
For Wallbed models:
INSTRUCTION BOOKLET #33
STORAGE HEAD BOARD
SIERRA
WARNING! ALL MURPHY/WALLBED SYSTEMS CONTAIN STORED ENERGY. FAILURE
TO USE AND FOLLOW THESE INSTRUCTIONS DURING THE INSTALLATION PROCESS
COULD RESULT IN SEVERE PERSONAL INJURY TO USER OR DAMAGE TO PRODUCT.
PLEASE CONTACT CUSTOMER SERVICE AT 866-725-6401 FOR ANY QUESTIONS.
Revision 7/14 BK33
Advertisement
Related Manuals for Wilding Wallbeds Sierra
Summary of Contents for Wilding Wallbeds Sierra
- Page 1 For Wallbed models: INSTRUCTION BOOKLET #33 STORAGE HEAD BOARD SIERRA WARNING! ALL MURPHY/WALLBED SYSTEMS CONTAIN STORED ENERGY. FAILURE TO USE AND FOLLOW THESE INSTRUCTIONS DURING THE INSTALLATION PROCESS COULD RESULT IN SEVERE PERSONAL INJURY TO USER OR DAMAGE TO PRODUCT.
- Page 3 studsensor...
- Page 4 5/8’’ Pan head Screw...
- Page 5 Step 1: Locate the two Side Boards. If you purchased a Queen size bed the Side Boards measure 85” long. Full and Twin size Side boards will measure 80” long. From the square white box locate the two Lift Mecha- nisms, hardware bag 7 and springs.
- Page 6 7/8” Washer...
- Page 7 Page 3...
- Page 8 Step 7: Assemble the Bed Cabinet face down with the bottom of the bed nearer the wall to which it will be installed by connect- ing Bridge Board, Head Board, and the two Stretchers as illustrated. NOTE: The front stretcher is posi- tioned so the cam fittings are on the BOTTOM of the bed.
- Page 10 Step 10: Locate the Front Panel(s) and lay them on the floor face down (finished side). Position them in front of where the Bed Cabinet was installed and leave enough room to work around them. Foot rail Step 11: Arrange the mat- tress rails on the face panels as shown.
- Page 13 Aluminium Center Stiffeners Step 17: Locate the three aluminium stiffeners, then one at a time remove the double stick tape cover from the back of the Stiffener and place it head to foot, join- ing two Bed Panels. Insure that the Stiffener overlaps equally onto the two face panels so one strip of double stick tape is attached to each panel.
- Page 15 IMPORTANT! As instructed in step 18, Bolt #3 should be loose enough to slip into the notch at the end of the Tension Arm See illustration below. #3 Bolt head Step 22: Stand the Bed face unit up on its Head Rail end. Now with you and your assistant on either side of the Bed face unit lift until the # 3 bolt on the Bed Tension Arm...
- Page 16 Page 12...
- Page 17 Step 25: When the bed is closed check to see if the gap Illustration 12 on either side is the same. If it looks right skip this step. If the gap is not right, meaning that the Bed Box is too close to the side board or even touching it at the top on one side it will need to be adjusted.
Need help?
Do you have a question about the Sierra and is the answer not in the manual?
Questions and answers