6.4 To install the cutting attachment guard
1. Attach the bracket (B) to the shaft with the screw
(D).
C
D
A
2. Attach the cutting attachment guard (A) onto the
shaft with the screw (C).
6.5 To attach and remove the trimmer head
1. Make sure that the cutting attachment guard (A) is
attached to the product. Refer to
cutting attachment guard on page 12 .
2. Make sure that the drive disc (C) is attached to the
output shaft (D).
12 - Repair instructions
B
To install the
D
C
B
A
3. Use a pin to lock the shaft in the bracket (B).
4. Put the trimmer head (E) on the output shaft.
5. Turn the trimmer head counterclockwise to tighten it
to the output shaft.
E
6. To remove the trimmer head do the steps in the
opposite sequence.
1023 - 001 - 24.04.2019