Crankshaft And Crankcase - Husqvarna 325L Workshop Manual

6.15.5 To install the cylinder and piston
1. Install the piston. The arrow at the piston top must
be in the direction of the exhaust port. Push in the
piston pin and attach the snap ring.
Note: Always use a new snap ring.
2. Lubricate the piston and piston ring with two-stroke
oil.
3. Carefully attach the piston ring on the piston. Make
sure that you do not cause damage to the piston ring
or the piston.
4. Put a new cylinder base gasket on the crankcase.
CAUTION: Make sure that the cylinder base
gasket does not have signs of damage and
wear.
5. Install the remaining parts in the opposite sequence
to how they were removed.
1023 - 001 - 24.04.2019

6.16 Crankshaft and crankcase

6.16.1 To disassemble the crankcase and
crankshaft
1. Remove the 3 screws.
2. Disconnect the crankcase halves.
3. Lift the crankshaft out of the crankcase half.
4. Remove the gasket.
Repair instructions - 29