Important Hints; Symbol; Safety Instructions; Operating Conditions - Hameg HZ547 Manual

I m p o r t a n t h i n t s
After unpacking check for mechanical damage
and loose parts floating around inside the in-
strument. In case of damage please inform the
transport company immediately. Do not operate
the instrument.

Symbol:

Please consult the manual

Safety instructions

Our measurement bridges did leave the factory
in perfect condition. They conform hence to the
European standards EN 61010-1 resp. IEC 61010-1.
In order to preserve conformity and ensure safe
operation the user is requested to observe the
guidelines and warning hints in this manual, the
test and service instructions.
Whenever it is suspected that safe operation may
be endangered the bridge should be taken out
of service and protected against unauthorized
operation.
Safe operation may be endangered if any of the
following is the case:
– The bridge shows visible damage.
– Loose parts floating around inside.
– The bridge does not function properly.
– After prolonged storage under un-favou-
rable conditions (e.g. in the open or in damp
rooms)
– Following excessive transport conditions (e.g.
the transport package did not correspond to
minimum requirements by mail, rail or other
carriers)

Operating conditions

The permissible operating temperature is +5 °C ...
+0 °C. During transport and storage the tempera-
ture may be –0 °C ... +70 °C. In case of condensati-
on after transport it is necessary to dry the bridge
for at least  hrs. prior to operation. The bridge is
destined for operation in clean, dry rooms.
1
Subject to change without notice

Important hints

Warranty and Repair

HAMEG instruments are subjected to a strict qua-
lity control. Prior to leaving the factory, each ins-
trument is burnt-in for 10 hours. By intermittent
operation during this period almost all defects are
detected. Following the burn-in, each instrument
is tested for function and quality, the specifications
are checked in all operating modes; the test gear
is calibrated to national standards.
The warranty standards applicable are those of
the country in which the instrument was sold.
Reclamations should be directed to the dealer.
Only valid in EU countries
In order to speed reclamations customers in EU
countries may also contact HAMEG directly. Also,
after the warranty expired, the HAMEG service will
be at your disposal for any repairs.
Return material authorization (RMA):
Prior to returning an instrument to HAMEG ask
for a RMA number either by internet (http://www.
hameg.com) or fax. If you do not have an original
shipping carton, you may obtain one by calling
the HAMEG service dept (+9 618 800 500) or by
sending an email to service@hameg.com.