Delay OFF-When the air conditioner is on,it can be
set to auto matically turn off in 1 to 24 hours.
How to set:
Press the Delay 1-24hr pad on the unit or th e DELAY
pad on the remote control. Each touch of the Increase/
Decrease pads on the unit or the Increase + / De-
crease - pads on the remote control will set the timer
in 1 hour intervals. The Set light will turn on while
setting.
To review the remaining time on the Delay 1-24hr
timer, press the Delay 1-24hr pad on the unit or
the DELAY pad on the remote control. Use the Increase/
Decrease pads on the unit or the Increase+/De-
crease- pads on the remote control to set a new
time if desired.
During preview of time or timer
setting,press Delay 1-24hr button on the panel
or Delay button on the remote controller to c-
ancel the timer setting.
Remote Control
To ensure proper operation, aim the remote control
at the signal receiver on the air conditioner.
The remote control signal has a range of up to 20
feet.Make sure nothing is between the air
conditioner and the remote control that could block
the signal.
Make sure batteries are fresh and installed correctly
as indicated on the remote control.
Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan
Speed for cooling. Use the Temperature Increase/
Decrease pads to set the desired temperature be-
tween 64
F and 86
The compressor will cycle on and off to keep the
room at the set level of comfort. Set the thermostat at
a lower number and the indoor air will become
cooler. Set the thermostat at a higher number and
the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned
on while set to a Cool setting or if turned from a fa n
setting to a Cool setting, it may take approximately 3
minutes for the compressor to start and cooling to
begin.
20
F in 1 F increments.
Cooling Descriptions
For Normal Cooling Select the Cool mode and High
or Med fan with a middle set temperature.
For Maximum Cooling Select the Cool mode and
High fan
with a
lower set temperature. For Quieter
& Night time Co
oling Select the
ow fan with a middle set
temperature.
Energy Saver Mode
The fan will cycle on and off with the compressor.T-
wider variations of room temperature a-
his
results
in
Normally used
when the room is unoccup-
nd humidity.
fan may continue to run
ied. NOTE:The
cycles off.
me after the compressor
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan sp-
eed to pr
ovide air
circulation and filtering without c-
ooling. Since fan
only settings do
ing, a Set temperature can
not be entered. The room
temperature will appear in the
NOTE:Auto Fan Speed cannot be used when in the
Fan Only Mode.
Auto Fan Speed
Set to Auto fan speed for the fan speed to autom-
atically set
to the
speed needed to provide optim-
um comfort settings
with the set
the room needs more cooling,
automatically increase.If the room needs
the fan speed
will automatically decrease.
NOTE:Auto Fan Speed cannot be used when in the
Fan Only Mode.
Power Outage Recovery Feature
In the case of a power outage or interruption, the u-
automati
cally restart in the settings last used
nit will
after the po
wer is restored. If
ure was set, it will
countdown
morized time
. You may need
desired.
Service Manual
Cool mode and L-
for a short ti-
not provide cool-
display.
temperature.If
the fan speed will
less cooling,
the Delay 1-24hr feat-
according to
the
me-
to set a new time if
Technical Information
Need help?
Do you have a question about the AEE07KP and is the answer not in the manual?