Low Energy; Operation; On-Off Switch; Mode Selection Switch - Manusa VECTOR Installation Manual

D00619EN - v0

3.3 Low Energy

The operator can be regulated in Low-Energy mode in accordance with standard EN16005, thanks to the following
features:
- Reduced dynamic force on the door threshold
- Restricted operator force and limited speed
The installer should check the Low-Energy installation conformity with applicable standards. Protection of the closing
edge should be evaluated individually.

3.4 Operation

manusa
doors are designed to operate automatically. Manual operation is only intended in the case of an emergency and to
carry out cleaning, maintenance and adjustment tasks.

3.4.1 ON-OFF Switch

A switch that turns the operator on and off:
See section 6 Commissioning in this manual

3.4.2 Mode Selection Switch

This switch is located on the head of the operator, next to the ON-OFF switch. It
enables mode selections:
I Manual
0 Automatic (two radars)
II Stop open
The installation of external switches voids the operation of this mode selection switch.

3.5 Installer Instructions

•
Follow the instructions carefully when installing the operator.
•
This product has been designed and manufactured to be used exclusively for the purposes indicated in this manual.
Any other use not expressly indicated may damage the product and/or be hazardous.
responsibility for improper use of the operator.
•
manusa
will not be held liable for non-compliance with good installation practices when installing locks, nor for any
warping that may be caused by their use.
•
Disconnect the electrical power supply before performing any type of intervention.
•
Check that the electrical installation has an upstream circuit breaker and proper earthing.
•
Safety devices should comply with standard EN 12978, and be installed in accordance with EN 16005.
Off
On
8
SWING OPERATOR - INSTALLATION MANUAL
manusa
accepts no