Decommissioning, Dismantling And Removal; Intended Use And Uses That Should Be Avoided - Manusa VECTOR Installation Manual

D00619EN - v0

3.6 DECOMMISSIONING, DISMANTLING AND REMOVAL

This machine can be easily dismantled, and decommissioning does not have any special complications.
Proceed to dismantle the unit removing the different elements, and discard and recycle waste accordingly.

3.7 Intended Use and Uses that Should be Avoided

The intended use for the VECTOR operator is to automate swing doors designed for pedestrian access. Prohibited uses that
should be avoided are listed below:
•
Do not modify the machine or any of its components.
•
Do not disconnect, manipulate or decommission any of the machine's safety components.
•
Do not allow technicians not authorised by
•
Do not use spare parts other than original ones supplied by
•
Do not use any part of the machine as support for objects and people.
•
Do not allow children to play with the machine.
This list includes inappropriate uses of the door that are reasonably foreseeable. Despite this,
responsible for possible accidents or damage caused by inappropriate uses not included in the list above.
3.8 Application Limits
IMPORTANT: For the correct operation of the operator, the door must not exceed the weight or width indicated in
diagram Fig. 2.
Closing the door is performed by:
- Motor assisted spring (normal operation)
- Only the spring (operating without power)
In addition, each transmission is assigned a different maximum depth value of the frame, above which a correct installation
cannot be carried out. The operator is designed to function exclusively on swing doors in dry environments, and should be
installed inside buildings.
manusa
is not responsible for damages arising from any use or placement different from that for which it was designed,
not for unauthorised modifications.
to perform work on the machine.
Fig. 2.
Leaf width (mm)
9
SWING OPERATOR - INSTALLATION MANUAL
shall not be held