Removing A Dimm From The Mediation Server Module - Avaya Secure Router 4134 Hardware Installation

Installing Avaya Secure Router 2330/4134 hardware components
4. Locate the DIMM slot on the module.
5. If the release latches on each end of the DIMM slot are engaged, release the latches
6. Insert the DIMM in the slot, pushing down firmly but gently to fully seat the DIMM in
7. Replace the Mediation Server Module in the chassis slot by aligning the module
8. Slide the module into the chassis until its connector panel touches the chassis back
9. Push gently, but firmly, to seat the connector on the interface module in the chassis
10. Ensure the lever on the module is flush with the front panel of the Secure Router
11. Using a Phillips screwdriver, tighten the two captive screws to secure the module

Removing a DIMM from the Mediation Server Module

Use the procedure in this section if you must remove a DIMM from the Mediation Server
Module.
Average time to remove a DIMM from the Mediation Server Module: 3 minutes.
82 Installation — Hardware Components
The following figure shows the DIMM slots.
by pushing each latch away from the DIMM slot.
the slot.
The release latches close when the DIMM is properly installed.
with the slot module guides.
panel.
back panel.
4134.
to the chassis.
Comments? infodev@avaya.com
August 2013