Removing The Internal Vpn/Ipsec Module - Avaya Secure Router 4134 Hardware Installation

Installing Avaya Secure Router 2330/4134 hardware components

Removing the internal VPN/IPSec module

Use the procedure in this section to remove a VPN/IPSec module from the Secure Router
4134.
Caution:
The internal VPN/IPSec module is not hot swappable. Do not open the Secure Router 4134
service access panel while the unit is powered.
Prerequisites
• Ensure you have a Phillips #2 screwdriver.
• Ensure the Secure Router 4134 has the power switched off.
• Ensure you have an antistatic bag or sheet available for the VPN/IPSec that you are
removing.
Procedure steps
1. Remove the two screws at the rear of the Secure Router 4134 that hold the service
access panel secure. Remove these two screws only. See the following figure.
2. Slide the access panel toward you until it is clear of the Secure Router 4134.
3. Remove the two screws that secure the VPN/IPSec module to the Main Board (see
the following figure).
72 Installation — Hardware Components
Comments? infodev@avaya.com
August 2013