Prerequisites; Installing A Small Module - Avaya Secure Router 4134 Hardware Installation

Electrostatic alert:
ESD
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack when working with interface modules.
Caution:
Risk of equipment damage
Always handle interface modules by the edges, or by using the levers, where applicable.

Prerequisites

• Ensure you have a Phillips #2 screwdriver.

Installing a Small Module

Use the procedure in this section to install a Small Module in the Secure Router 4134. For
instructions to install a Small Module in the VCMM, see
Router 4134 Voice Carrier Medium Module
Avaya recommends that you power down the Secure Router 4134 if you are installing an
interface module in a slot in which you have not previously installed that module type.
If you are working with 2- or 4-port FXS or FXO Small Modules, ensure you read the safety
messages related to the FXS and FXO interface modules. See
(FXS) Interface Modules
Modules on page 12.
Procedure steps
1. Using a Phillips screwdriver #2, remove the slot cover plate from the slot in which
2. Align the module with the slot and the slot module guides.
3. Slide the module into the chassis until its connector panel touches the chassis back
4. Push gently, but firmly, to seat the connector on the interface module in the chassis
5. Using a Phillips screwdriver, tighten the two captive screws to secure the module
Installation — Hardware Components
on page 11 and
you are installing the module.
panel.
back panel.
to the chassis.
Installing a Small Module in the Secure
on page 59.
Foreign Exchange Office (FXO) Interface
Installing the interface modules
Foreign Exchange Station
August 2013 57