Installing A Medium Module On The Secure Router 4134; Installing A Large Module On The Secure Router 4134 - Avaya Secure Router 4134 Hardware Installation

Installing Avaya Secure Router 2330/4134 hardware components

Installing a Medium Module on the Secure Router 4134

Use the instructions in this section to install Medium Modules.
Procedure steps
1. Using a Phillips screwdriver #2, remove the slot cover plate from the slot in which
2. Align the module with the slot and the slot module guides.
3. Slide the module into the chassis until its connector panel touches the chassis back
4. Push gently, but firmly, to seat the connector on the interface module in the chassis
5. Ensure the lever on the module is flush with the front panel of the Secure Router
6. Using a Phillips screwdriver, tighten the two captive screws to secure the module

Installing a Large Module on the Secure Router 4134

Install the Large Module in slots 6–7 only.
Procedure steps
1. Using a Phillips screwdriver #2, remove the slot cover plates from slots 6 and 7.
2. Loosen the captive screw at the top of the center slot module guide.
3. Remove the center slot module guide. The following figure shows the removal of
58 Installation — Hardware Components
you are installing the module.
panel.
back panel.
4134.
to the chassis.
the center slot guide.
Comments? infodev@avaya.com
August 2013