Installing Or Removing The Internal Vpn/Ipsec Module On The Secure Router 4134; Installing The Internal Vpn/Ipsec Module - Avaya Secure Router 4134 Hardware Installation

Installing Avaya Secure Router 2330/4134 hardware components
Installing or removing the internal VPN/IPSec module on the
Secure Router 4134
Use the instructions in this section to install, remove, or replace the internal VPN/IPSec module.
This internal module is not hot swappable.
If you ordered the VPN/IPSec module with your Secure Router 4134, the Secure Router ships
with the VPN/IPSec module installed.
Average time to install the internal VPN/IPSec module: 2 minutes.
Caution:
Do not open the Secure Router 4134 service access panel while the unit is powered.

Installing the internal VPN/IPSec module

Use the procedure in this section to install an internal VPN/IPSec module. If you are replacing
a VPN/IPSec module, also see
Prerequisites
• Ensure you have a VPN/IPSec module ready to install before opening the service access
panel.
• Ensure you have a Phillips #2 screwdriver.
• Ensure the Secure Router 4134 has the power switched off.
Procedure steps
1. Remove the two screws at the rear of the Secure Router 4134 that hold the service
70 Installation — Hardware Components
Removing the internal VPN/IPSec module
access panel secure. Remove these two screws only. See the following figure.
Comments? infodev@avaya.com
on page 72.
August 2013