IBM Aptiva Handbook page 86

8SGDWLQJ WKH &026 VHWWLQJV LQ 6HWXS
When you add Plug and Play adapter cards and drives, your
system's Basic Input/Output System (BIOS) detects the
hardware changes and updates the CMOS settings
automatically.
When you add devices that are not Plug and Play, you have
to enter Setup to manually assign resources (IRQs) to the
devices.
)RU DGDSWHU FDUGV
From the Advanced Setup menu, select
to view or change PCI adapter card information. See
Control
the section "Plug and Play Control" on page 6-10.
For other Plug and Play and non-Plug and Play adapter
cards, go to the Windows 98 Device Manager for
information.
8-12 Chapter 8: Adding and removing adapter cards and drives
)RU 'ULYHV
When you install a diskette drive, you should check the size
and storage capacity of the drive and make any required
changes in Setup. To specify the diskette drive size and
capacity, select the
main menu. See "Diskette Drive A/Diskette Drive B" on
page 6-11 for information about this option.
If you remove a diskette drive, hard disk drive, or CD-ROM
drive, the POST generates an error message. In Setup,
verify that the information the BIOS automatically recorded
is correct. Use this opportunity to verify that the remaining
drives are installed as intended.
Select Devices and I/O Ports from the Setup main menu to
Plug and Play
verify drive settings on page 6-11.
Normally, BIOS will auto-detect the HDD and CD-ROM drive
at the POST stage and show them on the screen.
option in the Setup
Devices and I/O Ports