Grounding - Graco E-Flo DC 333389E Instructions - Parts Manual

2-ball piston pumps
Table of Contents

Advertisement

Installation

Grounding

Grounding
Grounding
This equipment must be grounded to reduce the
risk of static sparking and electric shock. Electric
or static sparking can cause fumes to ignite or
explode. Improper grounding can cause electric
shock. Grounding provides an escape wire for the
electric current.
1. Connect the supply ground wire in the
electrical compartment as shown in
Connect the Supply Wiring, page
2. Connect a ground wire as shown in Fig. 5.
Loosen the ground screw and attach a ground
wire (Y, Graco part 222011, not supplied).
Tighten the ground screw securely. Connect
the other end of the ground wire to a true earth
ground.
Figure 5 Ground Wire
NOTE: Advanced models require installation
NOTE:
NOTE:
of a control module. All pumps connected to a
common control module must be grounded to
the same ground point. Different ground points
(unequal potential) may cause current to flow
through component cables, causing incorrect
signals.
Pump
Pump
Pump
ESx4xx
ESx8xx
ESxDxx
ESxHxx
Fluid hoses:
hoses: Use only electrically conductive
3. Fluid
Fluid
hoses:
hoses with a maximum of 500 ft. (150 m)
combined hose length to ensure grounding
continuity. Check the electrical resistance of
hoses. If total resistance to ground exceeds 25
megohms, replace hose immediately
4. Fluid
Fluid supply
Fluid
supply
supply container:
container:
container: Follow your local code.
5. Solvent
Solvent pails
Solvent
pails used
pails
used when
used
local code. Use only conductive metal pails,
placed on a grounded surface. Do not place
the pail on a non-conductive surface, such as
paper or cardboard, which interrupts grounding
continuity.
12
11.
Control Module
Module
Control
Control
Module
24P822
24X599
17V232
17V233
when flushing:
when
flushing: Follow your
flushing:
6. To
To maintain
To
maintain grounding
maintain
grounding continuity
grounding
or or or relieving
relieving pressure:
relieving
pressure: Hold metal part of the spray
pressure:
gun or valve firmly to the side of a grounded
metal pail, then trigger the gun or open the valve.
continuity when
continuity
when flushing
when
flushing
flushing
333389E

Advertisement

Table of Contents
loading

Table of Contents