Electrical Safety; Installation - Black+Decker Dustbuster NVB115W Original Instructions Manual

ENGLISH
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate and the information in the
technical data table.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
• Use your BLACK+DECKER charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
• Never attempt to charge nonrechargeable batteries.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised BLACK+DECKER
Service Centre in order to avoid a hazard.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
• The appliance/tool/battery must be placed in a well
ventilated area when charging.

Electrical safety

Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
Symbols on the charger
Read all of this manual carefully before using
the appliance.
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
The charging base is intended for indoor use
only.
Labels on appliance
The following symbols appear on this appliance along with
the date code:
Only use with charger S003AQ 15
Features
This tool includes some or all of the following features.
1. On/off switch (press and hold)
2. Bowl release button
3. Dust bowl
4. Charger
5. Charging bracket
Fig. A
6
(Original instructions)
6. Dry pick up cloth filter (NVB units Only)
7. Pre-filter (NVB units Only)
8. Wet/Dry foam insert (WDB units Only)
9. Wet/Dry deflector (WDB units Only)
Fig. B
10. Squeegee (WDB___WA units Only)
11. Brush tool (WDB___WA and NVB___WA units Only)
12. Crevice tool (WDB___WA and NVB___WA units Only)

Installation

Wall Mounting (fig. C)
The product can be attached to a wall to provide a
convenient storage and charging point for the appliance.
When fixing to a wall, make sure that the fixing method is
suitable for the wall type and is appropriate to the weight of
the appliance.
• Mark the location of the screw holes (within reach of an
electrical outlet for charging the vac while it is on the wall
bracket).
• Fix the mounting bracket to the wall using appropriate
screws and plugs for the type of wall and weight of the
appliance.
• Hang the appliance on the wall by placing the opening on
the base of the vac over the hooks in the wall mount
charging bracket.
Assembly
Accessories (fig .B)
These models may be supplied with some of the following
accessories:
• A squeege tool (10) for wet use on hard surfaces.
• A brush tool (11) for furniture and stairs.
• A crevice tool (12) for confined spaces.
Fitting (Fig. D)
• Insert the appropriate accessory into the front of the
appliance. Make sure that the accessory is pushed fully
in.
Use
• Before first use, the battery must be charged for at least
24 hours.
• Place the appliance on the charging bracket whenever it
is not in use.
Warning! Before charging, be sure to empty all liquid
contents and dry thoroughly, to avoid damage to your
appliance.
Charging the battery (Fig. C)
• Make sure that the appliance is switched off. The battery
will not be charged with the on/off switch (1) pressed.