Electrical Safety - Black+Decker BHFEV36B2D Manual

Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
+
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
$
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
sa charger 90616337-**
S010Q 23
90616337-**
Features
This tool includes some or all of the following features.
1. On/Off button
2. 3 speed power switch
2a. Beater bar activation button
3. State of charge indicator
4. 36V Battery
5. 36V charger
(Original instructions)
5a. Wall storage bracket (available to order through your
service department)
6. Lift away dust canister with filter agitator
7. Dust canister door
8. Floor head
9. Extension tube
10. 2 in 1 Accesssory tool
11. Crevice tool (available to order through service
department)
12. Accessory storage clip
13. Pet hair tool (available to order through your service
department)
14. Wide mouth dust brush
15. Hang hook for use with wall storage bracket (5a)
Charging a Battery
BLACK+DECKER chargers are designed to charge
BLACK+DECKER battery packs.
Note: To ensure maximum performance and life of lithium
ion battery packs:
Charge the battery pack fully before first use.
u
Recharge discharged batteries as soon as possible
u
after every use.
Do not discharge batteries fully.
u
Charging (Fig. A)
Plug the charger (5) into an appropriate outlet before
u
inserting the battery pack (4).
Insert the battery pack into the desk charger (5).
u
When using the the desk charger a green LED (5b) will
u
flash indicating that the battery is being charged.
The completion of charge is indicated by the green LED
u
(5b) remaining on continuously. The pack is fully charged
and may be used at this time or left on the charger.
Note: The battery includes a state of charge indicator to quick-
ly determine the extent of battery life. By pressing the state of
charge button (4a) you can easily view the charge remaining
in the battery.
Wall mounted vacuum storage (available
through your service department) (Fig. N)
The product can be attached to a wall to provide
convenient storage for the appliance.
When mounting to a wall, make sure the mounting method
is suitable for the wall type and is appropriate to the weight
of the appliance.
Mark the location of the storage bracket screw holes on
u
the wall.
Fix the wall storage bracket to the wall using appropriate
u
screws and plugs for the type of wall, and weight of the
appliance.
ENGLISH
7