PeakTech 1210 Operation Manual page 115

The operation steps for setting Channel 1 in Video Trigger Mode are as below:
1. Press the TRIG MENU button and get access to the trigger menu.
2. Press the F1 menu selection button and choose Single for Type.
3. Press the F2 menu selection button and choose CH2 for Source.
4. Press the F3 menu selection button and choose Video for Type.
5. Press the F4 menu selection button and choose Field for Sync. The screen display is shown as Fig. 34.
6. Press the F4 menu selection button again and choose Line for Slope. The screen display is shown as Fig.
35.
Fig. 34 Wave Form Triggered in the Video Field
114