Table of Contents
Advertisement
Preinstallation requirements
1. Place the server on its side on your working surface.
2. Turn the two thumbscrews on the back of the server counter-clockwise to loosen
3. Place your fingertips in the depression on the side cover, and then as you apply
4. Use one hand to pull the top edge of the cover away from the server to disengage
5. Use both hands to lift the cover upward to disengage the bottom row of tabs from
28
Avaya CallPilot® 703t Server Hardware Installation
them.
Note:
The thumbscrews are not removable.
Note:
If a removable screw is present, remove it. This screw secures the cover to the
server during shipping.
pressure, pull the cover approximately 25 mm (1 in.) away from the front of the
server until it stops.
the top row of tabs on the cover from the notches in the chassis.
the notches in the chassis.
December 2010
Advertisement
Table of Contents
