Otto Bock 3F1-1 Instructions For Use Manual page 9

These instructions for use provide you with important information on the use, adaptation and
handling of the product.
Only put the product into use in accordance with the information contained in the accompanying
documents supplied.
2 Product description
2.1 Design
The functional cosmesis consists of the following components:
2.2 Function
The product helps create the most natural possible appearance. The product forms the exterior
finish of a prosthesis. The product is not required for the proper and safe functioning of the pros­
thesis.
The functional shank is shaped by the O&P professional to create the most natural possible
appearance. Streaks, colour differences and small air pockets (up to 1 cm) in the functional
shank are concealed by the functional stocking. These differences, which are due to production
reasons, do not affect the function of the product and therefore do not constitute grounds for
complaints.
3 Application
3.1 Indications for use
The product is to be used solely for lower limb prosthetic fittings.
The product serves to finish the prosthesis in the sense of restoring a natural appearance that is
as inconspicuous as possible.
3.2 Area of application
The product is intended exclusively for wearers of the 3C98-3/3C88-3 C-Leg and
3B1-2/3B1-2=ST Genium.
1. Sheath
2. Functional stocking
3. Functional shank C-Leg / functional shank
Genium (referred to as "functional shank"
in the following)
4. Functional cosmesis C-Leg (knee part) /
functional cosmesis Genium (knee part)
(referred to as "functional knee part" in the
following)
9