red lion T16 Manual page 16

ANALOG OUTPUT RANGE (OPTIONAL)
:(,&
6.06 V 6.86
mA
<.86
mA
<.86
Select the type of output and range. The Analog output
jumpers are factory set to current. They must be changed if
voltage output is desired. The Analog output can be calibrated to
provide up to approximately 5% over range operation (0 mA
current can only go slightly negative).
ANALOG OUTPUT ASSIGNMENT (OPTIONAL)
:(:)
"& Main Control % Output Power
12& Input Signal Retransmission
"&
SP Active Setpoint
This setting selects the parameter that the Analog Output will
retransmit or track.
ANALOG UPDATE TIME (OPTIONAL)
:(%,
to
6 8=6 seconds
6
= update rate of 0.1 second
6
The update time of the Analog Output can be used to reduce
excess valve actuator or pen recorder activity.
STEP 7.3 MODULE 3 - Lockout Parameters (
SELECTION
dISP
Display: accessible in Display Loop.
HIdE
Hide: accessible in Hidden Loop.
LOC
Locked: not accessible in either loop.
Display/read: read only in Display Loop,
dSPr
(SP only)
but read/write in Hidden Loop.
The following parameters can be configured for
, , and
#"4 *1-' -1)&
.
OUTPUT
SETPOINT PID VALUES
POWER
ACCESS
ACCESS
)& "&
-1)& -1)&
0 mA or 4 mA output as selected.
V or 20 mA output as selected. An inverse acting output can be
achieved by reversing the low and high scaling points.
PARAMETER MENU
DESCRIPTION
ALARM
VALUES
ACCESS
ACCESS
&1- :#
*1-' *1-'
16
ANALOG LOW SCALING (OPTIONAL)
:(#"
.555 to 5555
67 6
The Analog Output assignment value that corresponds to 0 V,
ANALOG HIGH SCALING (OPTIONAL)
:(*1
to
.555 5555
0667 6
The Analog Output assignment value that corresponds to 10
ACCESS CODE
4;-'
.08= to 08=
6
Full access to Display, Hidden,
0
and Configuration Loops
Code necessary to access
to
-1 -125
Configuration Loop only.
Code necessary to access
1 to 125
Hidden and Configuration Loops.
The following parameters can be configured
for or only
#"4 *1-'
.
SETPOINT SETPOINT
SELECT RAMP
ACCESS ACCESS
)&)# )&+&
#"4 *1-'
AUTO-TUNE
START
ACCESS
,%('
*1-'
)
3.#4
CONTROL
TRANSFER
ACCESS
,+2/
#"4
RESET
ALARMS
ACCESS
:#+)
#"4