red lion T16 Manual page 11

!
Proportional Band, Integral Time, Derivative Time, Digital Filter,
Control Output Dampening Time, and Relative Gain (Heat/Cool)
values appropriate to the characteristics of the process. This
parameter allows front panel starting
Tune. For more information, see PID Tuning Explanations.
!
key resets Alarm 1 and the down key resets Alarm 2.
STEP 7.0 PROGRAMMING WITHIN THE CONFIGURATION LOOP
To access the Configuration Loop, press the up key when
is displayed in the Hidden Loop. The arrow keys are used to select
the parameter module (1-9). To enter a specific module press "
while the module number is displayed. In the Configuration Loop,
4(/& will alternate with the parameter number in the bottom display.
The Temperature/Process Value is shown in the top display.
After entering a parameter module, press " to advance through
the parameter names in the module. To change a parameter's
selection/value, press the arrow keys while the parameter is
displayed. In the modules, the top display shows the parameter
name, and the bottom display shows the selection/value. Use " to
enter any selection/values that have been changed. The change is
not committed to permanent memory until the controller is returned to
the Display Loop. If a power loss occurs before returning to the
Display Loop, the new values must be entered again.
At the end of each module, the controller returns to
location, pressing " again returns the display to the the Display
Loop. Pressing the Up key allows re-entrance to the Configuration
Loop. Whenever ! is pressed,
parameters are stored to permanent memory and the controller
returns to the Display Loop.
AUTO-TUNE START
"
,%('
(" ?')
("
The Auto-Tune procedure of the controller sets the
ALARMS RESET
"
:#+)
0.8
0.8
With alarm models, the alarms can be manually reset. The up
CONFIGURATION LOOP
'2- momentarily appears as the
!
3.#4
Code, access to the Configuration Loop is permitted (with a
negative Code value, the Hidden Loop can be accessed without
?') or stopping (" of Auto- the use of a code). With the factory setting of 0 or with an active
User Input configured for Program Lock (
not appear here. An active user input configured for Program
Lock (
of Access Code.
4(/& / ("
/ . At this
4(/& ("
11
ACCESS CODE
"
4;-'
.0 .08=
to
6
If the Access Code is set from -1 to -125, in Lockout Module
, Access Code will appear here. By entering the proper
) always locks out the Configuration Loop, regardless
&#"4
), Access Code will
&#"4