Power Zone™ Controller; Controller Features And Functions; Operator Screens; Alarm Mute - Generac Power Systems Magnum Series Operating Manual

POWER ZONE™ CONTROLLER
The Power Zone™ controller is an auto start controller that monitors the unit and indicates operational status and
fault conditions. The controller can be programmed to automatically start or stop based on time schedule, fault
condition, or load demand.
The controller constantly monitors vital generator and engine functions for a number of preprogrammed alarm and
fault conditions. When a fault condition occurs, the engine can be shut down automatically and the LCD window will
show the fault that caused the shut down; to resume operation, the fault condition must be resolved.
This controller also records a history of unit performance which may be viewed at any time and will not be lost when
the controller is powered down.
11
10
9
8
7
6
1. Navigation buttons
2. Control power switch
3. Engine start (manual mode)
4. Engine stop/reset
5. Main display
6. Auto/manual mode

CONTROLLER FEATURES AND FUNCTIONS

Operator Screens

These buttons are used to enter the various operator screens from any other screen. The operator screens consist
of four screens: Home (
screens, refer to Operator

Alarm Mute

The Alarm Mute ( ) button silences the audible alarm. Additional action will be required to fully disable the active
alarm.
33722 D
5
Figure 2-6. Power Zone™ Controller Layout
), Engine ( ), Generator (
Screens.
MMG130DI4/175DI4/205DI4 Operating Manual
4
7. Alarm mute
8. Voltage adjust
9. Generator
10. Engine
11. Home
), and Voltage Adjust (
GEN
General Information
STARTING THE GENERATOR
DAS STARTEN DES GENERATORS
COMIENZO DEL GENERADOR
COMMENCEMENT DU GÉNÉRATEUR
CONTROL CONTROL
ON ON
I 1
1. PRESS CONTROL POWER
SWITCH "ON"
O
CONTROL CONTROL
OFF OFF
2. PUSH ENGINE START "I"
CONTROL ON
I
2
O
CONTROL OFF
STOPPING THE GENERATOR
DAS AUFHÖREN DES GENERATORS
PARADA DEL GENERADOR
ARRÊT DU GÉNÉRATEUR
1. PUSH ENGINE STOP "O"
CONTROL CONTROL
ON ON
I
2. PRESS CONTROL POWER
SWITCH "OFF"
O
CONTROL CONTROL
OFF OFF
3
01780
). For information about the
+ -
V
13