Figure 20. Push The Release Knob Towards The Cartridge To Eject The Cartridge From The Slot; Figure 21. Push Magazine Until It Clicks Into Place - Tandberg Data StorageLibrary T40 T40 Installation And User Manual

If the cartridge falls down, it might be damaged and data could be lost.
Warning

Figure 20. Push the Release Knob towards the Cartridge to Eject the Cartridge from the Slot

Inserting a Magazine into the Unit
The right and left magazines are mirrored and can only be inserted into the correct left or right
magazine bay.
1. Enter the back of the magazine into the correct magazine bay. Make sure it is in level with the
library.
2. Slide the magazine carefully in until the eject spring engages.
3. Push the magazine further in against the spring until the magazine is latched.

Figure 21. Push Magazine until it Clicks into Place

Manual/Emergency Release of Magazines
In failure situations (either in the library itself, a power loss, or situations where you need to manually
release the magazines), a manual/emergency release is available. To activate the emergency
magazine feature, you must use the magazine release tool that is fastened to the rear of the library.
This tool must be inserted through the hole at the bottom of each magazine. See
Release Tool.
Make sure to turn off the power before you use the manual emergency release
Caution
tool
StorageLibrary Installation and User Guide
Figure 22. The
51