Roland CAMM-1 Pro PNC- 1410 Service Notes page 47

Enter the Service Mode by turning on the power while
3
pressing [ ], [ ] and [
with [ ], [ ] keys, and push the [ENTER] key.
Select "Cutter" with [
4
[ENTER] key. Push [TEST] key and then [ENTER] key.
- Landing Cut Test will start.
Push [ENTER] key and then [MENU] key.
5
- Landing Cut Test stops temporary.
In case of pen bouncing problem, increase the "ATK" and
6
decrease "BRK" with [
[ENTER] key for setting.
] keys. Select "Landing"
], [ ] keys, and push the
] and [ ] keys. Then push the
4 Adjustment
Sensor DRAM
EEROM Ageing
Press the [ ] key
seven times.
Force Key
Calib. Landing
ENTER
Select tool
Cutter Pen
ATK BRK
[CUT] 0 -1
TEST
Cut landing test
Start -> ENTER
ENTER
Cut AT 0 BR -1
Stop -> ENTER
Cut AT 0 BR -1
Stop -> ENTER
ENTER
Cut landing test
Start -> ENTER
MENU
ATK BRK
[CUT] 0 -1
ATK BRK
[CUT] 0 -1
ATK BRK
[CUT] 1 -2
4
45