Roland CAMM-1 Pro PNC- 1410 Service Notes page 20

3 Replacement of Main Parts
3-1 PEN CARRIAGE ASSEMBLY_FIXING
Make sure there is no looseness in the PEN CARRIAGE
1
ASSEMBLY when fixing it to the GUIDE RAIL.
3
Put the 0.25 mm ink pen to the PEN CARRIAGE
2
ASSEMBLY and push it down with your finger at the
positions shown in the figure. Make sure that the pen tip
lands within +/- 0.5 mm from the center of the CUTTER
PROTECTION. If not, fix the PEN CARRIAGE ASSEMBLY
again.
18
GUIDE RAIL
PEN CARRIAGE
ASSEMBLY
CUTTER
PROTECTION