Roland CAMM-1 Pro PNC- 1410 Service Notes page 19

3 Replacement of Main Parts
Following table describes the necessary adjustment after the replacement of each parts.
Replacement Parts
CARRIAGE MOTOR ASSEMBLY
DRIVE GEAR
GRIT MOTOR ASSEMBLY
ROLL DRIVE GEAR
CARRIAGE WIRE
PEN CARRIAGE ASSEMBLY
MAIN BOARD ASSEMBLY
POWER BOARD ASSEMBLY
3-1 PEN CARRIAGE ASSEMBLY_REMOVING
Remove the CARRIAGE COVER.
1
Remove SCREW A and WASHER fixing the wire.
Remove the CARRIAGE CABLE and the CARRIAGE
2
BOARD ASS'Y.
Remove the CARRIAGEBOARD STAY and take off the PEN
3
CARRIAGE ASSEMBLY.
Necessary Adjustment
Motor Backlash Adjustment, Wire Tension Adjsutment, Motor Balance Adjustment
Motor Backlash Adjustment, Wire Tension Adjustment
Motor Backlash Adjustment, Motor Balance Adjustment
Motor Backlash Adjustment
Wire Tension Adjustment
Tool Height Adjustment, Pen Pressure Adjustment
Pen Pressure Adjustment
Motor Balance Adjustment, Calibration
CARRIAGE COVER
CARRIAGE CABLE
PEN CARRIAGE
ASSEMBLY
3 Replacement of Main Parts
SCREW A
WASHER
CARRIAGE
BOARD ASS'Y
CARRIAGEBOARD
STAY
17
3