Removing The Drive Cage Cover - HPE Edgeline EL300 Maintenance And Service Manual

3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Remove the antennas on the system.
5. Remove the installed bracket option.
6. Remove the security cover.
7. Remove the drive cage cover.
8. Remove the heat spreader.
To replace the component, reverse the removal procedure.

Removing the drive cage cover

Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-15 security screwdriver
• Phillips screwdriver
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
36 Removal and replacement procedures