To replace the component, reverse the removal procedure.
Removing and replacing the cable management bracket
Prerequisites
Before you perform this procedure, make sure that you have the T-15 security screwdriver available.
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Place the system on a flat, level surface.
5. Remove all the cables routed through the cable management bracket.
6. Remove the cable management bracket.
30
Removal and replacement procedures