Removing And Replacing The M.2 Device - HPE Edgeline EL300 Maintenance And Service Manual

a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Place the system on a flat, level surface with the top cover facing down.
5. Remove the antennas on the system.
6. Remove the installed bracket option.
7. Remove the security cover.
8. Remove the drive cage cover using the Philips screw driver.
To replace the components, reverse the removal procedure.

Removing and replacing the M.2 device

Prerequisites
Before you perform this procedure, make sure that you have the Phillips screwdriver available
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Remove the security cover.
Removal and replacement procedures 37