Removing And Replacing The Sd Card - HPE Edgeline EL300 Maintenance And Service Manual
Converged edge system
Hide thumbs
Also See for Edgeline EL300:
- Getting started manual (36 pages) ,
- Setup and configuration manual (91 pages) ,
- Product end-of-life disassembly instructions (3 pages)
Table of Contents
Advertisement
5. Remove the drive cage cover.
6. Remove the drive cage.
7. Remove the M.2 installed on the drive cage.
To replace the components, reverse the removal procedure.
Removing and replacing the SD card
Prerequisites
Before you perform this procedure, make sure that you have the T-10 screw driver available.
Procedure
1. Access the rear panel of the system.
2. Remove the SD port cover from the rear panel of the system.
3. If installed, remove the serial port connector.
4. Remove the SD card installed:
38
Removal and replacement procedures
Advertisement
Table of Contents
