Removing And Replacing The Brackets; Removing And Replacing The Base Only Bracket - HPE Edgeline EL300 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing the brackets

Removing and replacing the base only bracket

Prerequisites
Before performing this procedure, make sure that you have the T-15 security screwdriver available.
Procedure
1. Power down the system.
2. Remove all power:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Place the system on a flat, level surface.
5. Remove the cable management arm.
6. Remove the base only bracket.
Removal and replacement procedures 31