Removing And Replacing The Dust Covers - HPE Edgeline EL300 Maintenance And Service Manual

a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the system.
3. Depending on the surface the system is installed on, do one of the following:
a. Dismount the system from wall.
b. Dismount the system from the rails.
4. Place the system on a flat, level surface with the top cover facing down.
5. Remove the antennas on the system.
6. Remove the installed bracket option.
7. Remove the security cover.
8. Remove the drive cage cover.
9. Do one of the following:
• If installed, remove the drive from the drive cage and disconnect all drive cables.
• Remove the standoff (Hex nut) screw securing the SATA cable and I2C cable.
10. Remove the drive cage.
To replace the components, reverse the removal procedure.

Removing and replacing the dust covers

Procedure
Remove the dust cover
24 Removal and replacement procedures