Set Fixture Parameters; Dmx Address; Info Menu - ETC High End Systems SolaWash 1000 User Manual

Set Fixture Parameters

This section provides instructions to configure and set up the SolaWash 1000. See
User Interface on the previous page
Provide power to the fixture before configuring it. If you do not provide power, the fixture will
use battery power to power the user interface.

DMX Address

Navigate: Main Menu → Address
Set the DMX address for the fixture. The default value is 001.

Info Menu

Set the Time Information
Navigate: Main Menu → Info → Time Info
Parameter
Current Time
Ttl Life Hrs
Last Run Hrs
LED Hours
Timer PIN
Clr Last Run
LED Time PIN
Clear LED Time
Configure the Fixture
for information about the navigation buttons.
Value
Running time of the fixture from the last time that
XXXX (Hours) the fixture was powered on, shown in hours (h). The
counter resets after the fixture is turned off.
XXXX (Hours) Total running time of the device, shown in hours (h).
Running time of the fixture from the last time that
XXXX (Hours)
the run time value was reset, shown in hours (h).
Total running time of the fixture LEDs, shown in
XXXX (Hours)
hours (h).
You must enter the Timer PIN in order to access the
Timer PIN XXX Clr Last Run menu item. The default Timer PIN is
038.
This password-protected menu item resets the Last
Run Hrs value. You must enter the Timer PIN to
ON
• access this menu item.
OFF
•
Select ON to clear the value for the Last Run Hrs
parameter for the fixture.
You must enter the LED Time PIN in order to access
LED Time PIN
the Clear LED Time menu item. The default LED
XXX
Time PIN is 038.
This password-protected menu item resets the LED
Hours value. You must enter the LED Time PIN to
ON
• access this menu item.
OFF
•
Select ON to clear the value for the LED Hours
parameter.
Navigate the
Description
17