Programmable Outputs; Keypads (Pcx-Lcd/Uk); Tag Readers (Pcx-Prox/Int & Pcx-Prox/Ext); Arm Points - Pyronix PCX-256 Installation Manual

1.2.2 Programmable Outputs (PGM)
PGM Outputs On-
Board
Output Expander
PGM Outputs
PGM Types

1.2.3 Keypads (PCX-LCD/UK)

Type
Maximum Number of
Keypads
1.2.4 Tag Readers (PCX-PROX/INT & PCX-PROX/EXT)
Types
Maximum Number of
Readers

1.2.5 Arm Points

Maximum Number of
Arm Points

1.2.6 Partitions

Number of Partitions/
Arm Modes
Arming Options
RINS869-8
PGM1, PGM2: Relay (NC,C, NO), Speaker Output, PGM4, PGM5:
Transistor (Active High, Low)
PCX Remote Output Expander 16 Way Relay Outputs. (PCXROX16R
or PCXROX16R/PSU)
Approx: 132 (4 on board + 8 ROXs)
Note: PGMs also on RKPs, RIXs and Readers.
Not Used, Fire, Hold Up Any, Intruder Any, Final Set All, Misoperation,
Confirmed Any, Tamper Any, Duress Any, HU Device Any, Gas, Set
Fail, Entry Deviation, Secure Intruder Any, Siren Any, Strobe Any, Omit
Rearm Any, Unconfirmed Any, Can Set All, Exit Starts All, Exit Starts
Any, Final Set Any, Strobe Set Fail, Keyswitch Unset, Set With Omit,
Entry, Exit, Entry / Exit, Lights, Follow Input, Shunt Fault, Restore 1,
Restore 2, PIR Latch 1, PIR Latch 2, Mains Good, Detr Indn Enable,
Follow Test, Off During Test, Detr Walk Test, Line Fault, Mains Fail,
Battery Fault, Low Volts, Global Fault 1, Global Fault 2, Germany
Relay, Guard Code Used, Engineer Access, Initialise Digi, Test
ATE/GSM, Test ATS, Zone Activity F1, ATE not used, Hold up (area),
Intruder (area), Final Set (area), Tamper (area), Duress (area), HU
Device (area), Fire Reset A, Secure Intruder (area), Siren (area),
Strobe (area), Omit at rearm (area), Unconfirmed (area), Can Set
(area), Exit Starts (area).
LCD with integral tag reader. 32 character
16 Keypads
Internal Tag Reader with 2 inputs & 2 outputs
External Prox Reader
15 Internal Readers / 7 External Readers
30 Arm Points
14 Partitions or 14 Arm Modes
Timed Exit, Final Exit, Timed/Final, Push to set,
P C X 2 5 6 I N S T A L L A T I O N M A N U A L
Page: 7