Stu/Ate Output Pins; Stu/Ate Plug-On Loom Diagram; Stu/Ate 14 Pin Connector Diagram - Pyronix PCX-256 Installation Manual

P C X 2 5 6 I N S T A L L A T I O N M A N U A L

10.4.3 STU/ATE Output Pins

COM LOOM
1 (Blue)
2 (Orange)
3 (Yellow)
4 (Brown)
5 (Purple)
6 (Green)
7 (Black)
8 (Purple)
9 (White)
10 (Light Grey)

10.4.4 STU/ATE Plug-On Loom Diagram

For programming / changing the ATE outputs please see 'CHANGE OUTPUTS' in the
Please note that ATS Output 10 can only be used as any output type if the Line Fault (Black wire)
is disconnected. If the Line Fault is connected then 'Test ATS (0064)' can only be used.

10.4.5 STU/ATE 14 Pin Connector Diagram

The 14 pin connector can be found on the top left hand side of the PCX printed circuit board. The
pins are numbered below. Please see above for the corresponding outputs.
Page: 34
Default Type
Fire
HU Device Any
Unconfirmed Any
Final Arm Any
Tamper Any
Confirmed Any
Omit Rearm Any
AC Fail
Global Fault 2
Test ATS
Purple (ATE Output 8)
Light Grey (ATE Output 10)
White (ATE Output 9)
Black (ATE Output 7)
Brown (ATE Output 4)
Red (0V)
Orange (ATE Output 2)
Yellow (ATE Output 3)
Green (ATE Output 6)
Blue (ATE Output 1)
Purple (ATE Output 5)
Light Grey (+12V)
White (Red Care Reset/Failed To Communicate)
Black (Line Fault)
programming manual RINS869
10
(Light 7 0v 3
Grey) (Black) (Red) (Yellow)
8 9 4 2
(Purple) (White) (Brown) (Orange)
+12v
1 (Light Line Fault
(Blue) Grey) Input (Black)
6 5 RCR, Failed to
(Green) (Purple) Comm (White)
PGM Number
0001
0009
0018
0022
0007
0006
0017
0052
0056
0064
RINS869-8