The Internal Reader (Pcx-Prox/Int); The External Reader (Pcx-Prox/Ext); R Eader (Pcx-Prox/Int) - Pyronix PCX-256 Installation Manual

P C X 2 5 6 I N S T A L L A T I O N M A N U A L
5 . 2 T h e I n t e r n a l R e a d e r ( P C X - P R O X / I N T )
The internal tag reader uses prox tags (as shown below) and prox cards.
The Alert LED will flash if there is information available to you.
Enter your code to see the information on the Keypad. After a
code has been entered, one of the following LEDs will
illuminate: Tamper or Fault. The relevant detail of the problem
will be shown on the display. To clear the display, press the
'Yes' key or present your tag.
This indicates when an alarm activation as occurred.
This indicates when a tamper has occurred.
This indicates when a fault has occurred, i.e. device fail etc.
This will illuminate for a couple of seconds after the system
5 . 3 T h e E x t e r n a l R e a d e r ( P C X - P R O X / E X T )
The external tag reader uses prox tags (as shown below) and prox cards.
This indicates that the reader is ready to accept a tag. This will
extinguish after a couple of seconds.
This can be programmed to follow an output (For example you
may want the output to illuminate when a partition is armed).
For more information on this please see 'Change Outputs'.
Page: 20
ALERT LED
ALARM LED
TAMPER LED
FAULT LED
DISARMED LED
has been disarmed.
GREEN LED
RED LED
RINS869-8