Addressing The Radio Expander; Assigning Radio Detectors; Deleting Radio Detectors; Display The Signal Strength - Pyronix PCX-256 Installation Manual

6 . 4 A d d r e s s i n g T h e R a d i o E x p a n d e r
Once a radio expander is installed on the system in must be enabled at both the radio expander
and the PCX system. To perform this at the system you will need to go to 'Install RIX', see the
programming manual. To enable this at the radio expander, follow the instructions below:
Hold down the 'ENTER' button until the mode and address
are displayed.
"E0" = means End of Line mode, Address 0.
"I0" = means ID mode, Address 0.
Press the 'MO' button on the detector to toggle between
End of Line and ID modes.
Press the 'AZ' button to select the Wireless Input Expander
address number.
Press the 'ENTER' to confirm your selection.
6 . 5 A s s i g n i n g R a d i o D e t e c t o r s
Press the 'AZ' and scroll to the input number you wish to
assign a wireless detector to:
Press the ''RESET' button on the detector you wish to
assign to that particular zone.
Ensure that the jumper on the detector PCB is placed in the
"EU" position. When the detector is assigned, the two dots
on the display with flash.
6 . 6 D e l e t i n g R a d i o D e t e c t o r s
Press the 'AZ' and scroll to the input number you wish to
delete.
Press the ''CLEAR' button. The dots should have cleared,
indicating the detector has been deleted.
6 . 7 D i s p l a y t h e S i g n a l S t r e n g t h
The radio expander can monitor the signal of the detectors connected onto the system:
Press the 'AZ' and scroll to the input number you wish to
check. The display will show the input number and two dots.
Activate the detector and the signal strength will be
displayed (0-99). If it is below 14, use a REPEATER to boost
the signal.
RINS869-8
P C X 2 5 6 I N S T A L L A T I O N M A N U A L
ENTER
AZ
AZ
AZ
CLEAR
AZ
E 0
1 E
1 0
1 0
1 0
1 0
1 0
9 6
Page: 23