The Pcx Panel Layout; Battery Installation Procedure; Mounting Procedure For Devices - Pyronix PCX-256 Installation Manual

4 . 4 T h e P C X P a n e l L a y o u t
Battery
17Ah
4 . 5 B a t t e r y I n s t a l l a t i o n P r o c e d u r e
Place two foam pads on the bottom of the battery and two on the upper rear. Place the battery in
the case and secure with two tie wraps.
4 . 6 M o u n t i n g P r o c e d u r e f o r D e v i c e s
Mount the equipment carefully in suitable locations, noting particularly the following:
Input expander units (RIXs or RIX2s) should be located to suit the wiring to appropriate
detectors. Mounting more than two together is not recommended.
Where input expanders, output modules or access controllers are mounted on power supplies,
all connections are automatically made to draw all current from the power supply, and to use
the system diagnostic capabilities to control the power supply.
Intelligent power supplies cannot be used in isolation from the PCX system plug-on PCBs.
Keypads and tag readers should NOT be mounted on or near a metal surface, or within a
metre of each other, or tag response could be affected.
Where provided, metal housings must have the earth strap connected to the lid to meet
electrical safety regulations.
RINS869-8
NO2
NC2
A UX+
P GM3
P GM4
P GM5
17Ah
Fuse carrier handle
(fuse nominal - 250mA)
Neutral
Live
Earth
P C X 2 5 6 I N S T A L L A T I O N M A N U A L
DIGI MODEM CARD SLOT
EXPANSION CARD SLOT
NO1
C1
NC1
C2
F1
B T
B -
B +
F3 F4 F5
F2
To Mains Supply
Main Cable
Entry Hole
Tamper Switch
Wall Fixing
T-1 R-1 TIP RING
Holes
Cable
Entry Holes
Mains
Transformer
Page: 15