Battery Removal And Installation - Supermicro C9X299 User Manual

Super C9X299-PG300F User's Manual

3.4 Battery Removal and Installation

Battery Removal
To remove the onboard battery, follow the steps below:
1. Power off your system and unplug your power cable.
2. Locate the onboard battery connector (BT1) on the motherboard.
3. Carefully remove the jumper from the connector.
4. Remove the battery.
Proper Battery Disposal
Please handle used batteries carefully. Do not damage the battery in any way; a damaged
battery may release hazardous materials into the environment. Do not discard a used battery
in the garbage or a public landfill. Please comply with the regulations set up by your local
hazardous waste management agency to dispose of your used battery properly.
Battery Installation
1. To install an onboard battery, follow steps 1 and 2 above and continue below:
2. Connect the new battery's jumper to the BT1 connector.
Important: When replacing a battery, be sure to only replace it with the same type.
66