Filament Run-Out Sensor (Optional); Touch For Auto Bed Leveling (Optional) - Geeetech A10T User Manual

10.3Filament run-out sensor (Optional)

Before using this function, please check whether it is turned on or not. Choose
"Control">"Filament">"Runout sensors" and after entering the menu, make sure that "Runout
sensors" is "On". See pictures (10-3, 10-4).

It will pop up the notification "Err: No Filament" when the filament is run out during
printing and the printer will stop. See picture (10-5).

Press the extruder handle, remove the remaining filament before loading the new filament.

When the filament is loaded, use a tweezers to clean the nozzle. Press the knob to enter the
main menu, and choose "Resume print" to re-start the printing. See picture (10-6).
10.4 3D touch for auto bed leveling (Optional)
This printer supports auto bed leveling. Refer to the link below to know how to install the 3d
touch sensor.
https://www.youtube.com/watch?v=_RtsZDbR2po&t=66s
Visit our official forum
http://www.geeetech.com/forum/
Shenzhen Getech Technology Co.,Ltd
(Picture 10-3)
(Picture 10-5)
(Picture 10-4)
(Picture 10-6)
50